Quartz stone countertop processing and installation selection treasure carving CNC

Quartz stone countertop processing and installation selection treasure carving CNC

Release date :2018-06-11 Browse times:224

Nowadays, most of the malls, cabinets, and countertops are the best choices. Compared with the processing and installation of other quartz stones, the technology is relatively high. Improper installation will not only affect the appearance of the countertops, but also Directly affect the overall quality and service life of the cabinet. Quartz stone countertops processing and installation of Bao Xuan CNC 15 years professional cnc numerical control equipment manufacturers, the national service hotline 0551-63454286.

When designing and processing quartz stone, pay attention to:

First, the quartz stone is generally installed by splicing. Everybody chooses the splicing position to try to avoid the corners and the mouth of the furnace. This is because the quartz stone has the characteristics of thermal expansion and contraction, if it is close to the fire or corner, Cracking may occur.

Secondly, when designing the countertops, everyone should fully consider the stress concentration and cause cracks at the corners of the countertops. Therefore, when processing, all arc angles with a radius of 2.5 cm or more must be maintained at all corners.

Third, when designing the open position of the cooktop, the open position of the mesa should be greater than or equal to 8 cm from the edge of the mesa.

To prevent cracking on the face of the table, when opening the table, first use a cutting machine or a jig saw to open the hole, and then use a rake or hand grinder to polish the trim to achieve a smooth effect. The corners are basically uniform in radius, because the jig saw , Cutting machine opening, the hole around the hole sawing there are printed to the cracks, it is easy to cause cracking at the hole.

Fourth, the opening hole should maintain a radius of more than 2.5 cm round corners, four corners must be used to strengthen the plate with a homogeneous plate, the stove and the table should have a certain space, the space distance is 0.3-0.6 cm, Put insulation cloth and tin-platinum paper as insulation protection measures around the hole.

Fifth. When designing a countertop, consideration should be given to the restrictions on the dimensions of the countertops by staircases, elevators, doors, etc. The on-site joints shall meet the requirements of the aforementioned joints.

Installing quartz countertops Remember:

First, before installation, you need to check the flatness of the cabinet and check whether the quartz stone countertop size exactly matches the cabinet. If an error occurs, quartz stone countertops need to be reworked or the cabinets trimmed.

Second, when measuring the depth of the cabinet body, the table top needs to reserve a size of 4cm so as to facilitate the installation of the lower hanging edge strip.

Third, in the mosaic of some long table (such as L-type table), in order to ensure the flatness of the mosaic table and the tightness of the joints, it is recommended to use a strong clip (A folder, F folder) on the quartz stone plate fixed. In addition, when bonding the hanging bar, it is also necessary to use a strong fixing clip to ensure that the table top is spliced and the gap between the table top and the bottom bar is perfectly combined.

Fourth. There should be a certain distance between the quartz stone countertop and the wall (usually 3mm to 5mm). After the installation is completed, glass glue should be evenly applied on the gap between the countertop and the wall.

Fifth. Due to the high hardness and density of quartz stone countertops, the processing technology requires a higher level. Therefore, quartz stone countertop installation should contact the professional quartz stone installation master, and use professional tools to install, must not be blindly installed, so as to avoid unnecessary trouble.